Red Sleeper
Active member
- Joined
- Aug 11, 2009
- Messages
- 4,613
My bet is material issue that could be unknown to the manufacture. I’m seeing this in my field of work very often sense the middle of 2020.
OEM specs are the same, material suppliers are providing a material that barely meets spec, no one really asks the question because all has been fine for years before. Not blaming the cam grinder or the material supplier. The issue likely traces back to the raw good manufacture. All speculation of course.
On a similar note, someone else on here has suspect cam wear recently. First gen area. I’ll dig around.
OEM specs are the same, material suppliers are providing a material that barely meets spec, no one really asks the question because all has been fine for years before. Not blaming the cam grinder or the material supplier. The issue likely traces back to the raw good manufacture. All speculation of course.
On a similar note, someone else on here has suspect cam wear recently. First gen area. I’ll dig around.