DISTURBED
YEA WE RIDE THE SHORT BUS
- Joined
- Nov 22, 2007
- Messages
- 6,417
Hey Jeremy what was your piston to wall? I ran into this issue a few times as well when the PTW is larger than spec
.010 ptw clearance
Hey Jeremy what was your piston to wall? I ran into this issue a few times as well when the PTW is larger than spec
Mahle rings? Every set of over bore rings have been way on the high side out of the box that we've used.
Also, .001 extra bore = .003 ring gap
Just use .040" over rings and file to fit.
You are talking about .020 on the circumference of a 4" bore. It will not impact the concentricity of the circle near as much as you are all thinking....