114 mm turbo

[boostedve]

do you think it be possible to spool a 114mm turbo in a set of twins..
p pump motor 12v, its for dragracing what would you use for a top turbo..

its a pt 114mm billet wheel with a t5 1.32a/r exhuast housing.

 

[Scorpiont]

I think that you might have a bit of trouble spinning that one up.

 

[SMOKIN93]

What size exhaust wheel? I bet you could make it work

 

[12vriviera]

is that 114 mm exducer or inducer on intake side?

 

[ILLINOISRAM]

hell id run it as a single charger just put a custom machined .90 housing for it.

 

[ElliotB_16]

why not go bigger

 

[DRTurbo]

What size exhaust wheel? I bet you could make it work

That turbo is 114mm inducer with 141mm exducer, turbine wheel is 130mm inducer and 111 exducer. Meant for 500-600ci gas motors running 2000+hp as a single.

 

[JQmile]

You'd need lots of fuel to keep the drive pressure up and probably 5K rpm.

 

[JasonCzerak]

Apparently a CR and a stand alone....

 

[Big Blue24]

You could make it work with a wet nitrous kit plumbed into the exhaust housing with a little water injection for extra mass flow in the form of steam!

 

[boostedve]

what about twins...

 

[Later]

Maybe compounded triples.