gearhart73
New member
- Joined
- Jul 26, 2011
- Messages
- 779
I bought this 2006 as a roller with a rebuilt title to build into a farm truck. It's regular cab 4wd st model truck with 218k miles on it. I went through the front and rear axles to put all new bearings, seals, u joints, and ball joints. And then the build turned into a little more than just a farm truck. So here a quick break down.
6.7 Cummins:
ATS dual fuelers
250% injectors
Fleece distribution block
Airdog 4g
Fleece coolant by pass
Flex a lite fans
Fluid dampener
14mm gorilla girdle
Line bored with cam bushings
Carrillo rods
Hamilton 188-220
Lots of head work
All of the machine work on the block and head was done through Haisley Machine
Trans is a firepunk comp 2 with an upgraded front drive shaft
Air:
Steed speed comp t-4 with dual wastgate ports. Both are capped off right now but you have the option to mount 2 wastegate to it if you wanted later.
Firepunk built 66/84
One 3 intercooler
I put all new AC components on it but haven't had it charged yet
I'm running the 5.9 electronics with the 6.7 engine. Firepunk tuned it with a 5 position switch. For some reason the truck would engage the starter with the key so we put a push button start in it.
The only odd thing I know so far is that the truck vibrates at ideal. I'm not sure if it's due to the semi solid motor mounts or what but as soon as you touch the throttle it smooths right out.
I've only put 200 miles on the build. It drives really nice and it's fun to drive. I just have an opportunity to buy something else so I'm looking to free up some extra cash.
Im leaving stuff out but basically it's 200k mile body and frame with a bunch of new parts around it. Looks like a basic silver farm truck but it laid down 1200hp on the dyno.
I'm located in Kingston, OH 45644
$35,000
6.7 Cummins:
ATS dual fuelers
250% injectors
Fleece distribution block
Airdog 4g
Fleece coolant by pass
Flex a lite fans
Fluid dampener
14mm gorilla girdle
Line bored with cam bushings
Carrillo rods
Hamilton 188-220
Lots of head work
All of the machine work on the block and head was done through Haisley Machine
Trans is a firepunk comp 2 with an upgraded front drive shaft
Air:
Steed speed comp t-4 with dual wastgate ports. Both are capped off right now but you have the option to mount 2 wastegate to it if you wanted later.
Firepunk built 66/84
One 3 intercooler
I put all new AC components on it but haven't had it charged yet
I'm running the 5.9 electronics with the 6.7 engine. Firepunk tuned it with a 5 position switch. For some reason the truck would engage the starter with the key so we put a push button start in it.
The only odd thing I know so far is that the truck vibrates at ideal. I'm not sure if it's due to the semi solid motor mounts or what but as soon as you touch the throttle it smooths right out.
I've only put 200 miles on the build. It drives really nice and it's fun to drive. I just have an opportunity to buy something else so I'm looking to free up some extra cash.
Im leaving stuff out but basically it's 200k mile body and frame with a bunch of new parts around it. Looks like a basic silver farm truck but it laid down 1200hp on the dyno.
I'm located in Kingston, OH 45644
$35,000
Last edited: