ATS Intake that doesn't fit and they say tuff!

Problem solved!! Nothing a little pipe, welder, and some time can't take care off.
 

Attachments

  • P1013560 (Small).JPG
    P1013560 (Small).JPG
    61 KB · Views: 56
  • P1013561 (Small).jpg
    P1013561 (Small).jpg
    47.6 KB · Views: 45
I have never heard of one blowing apart from high boost only. Now people drilling and tapping them ... I have heard of problems
 
When i was a dtt I saw they were making intakes,anyone using one of theirs yet?sorry to hijack,looks good
 
I only know of one guy and haven't heard anything back from him. It's a real nice piece. Only thing I didn't like about it was the way the ports were tapped. The base plate is 1/4"-3/8" thick and the holes are tapped at a 30-45* angle from the top edge of the plate facing down in to the motor. When you match the gasket up to that it looks like half the hole is blocked by the gasket. Which to me would be bad if your injecting stuff.
 
really?!??! :umno::bs:
showing your own lack of knowledge about the trucks your company makes products for! :clap:

I can agree on this one...

I called ATS Because i had a question about my 93 and the person on the phone told me that Dodge didnt start putting intercoolers in the trucks till 94:bang

I continued to tell the person that yes they did, i have a intercooled 93 and they put them on begining in 91.5(IIRC) And they replied.. oh you must have a early 94:bang:bang:bang
 
Back
Top