Dekalb Super pull?

diesel2005

New member
Joined
Nov 15, 2008
Messages
62
Does Any one have any info on the 2010 Dekalb Super pull in Eaton Ohio as far diesel truck classes go?
 
LOL This rule eliminates 80+% of the 2.6 trucks out there.

The vehicle is limited to a single turbocharger; the inducer bore on the compressor housing may be no larger than 2.6 inches measured at the smallest diameter area of the compressor wheel. The inlet will be measured using a 2.65-inch plug or internal calipers. The largest diameter of the intake compressor wheel must not exceed 100 mm. A stock map width enhancement (MWE) groove is allowed. No MWE groove will be allowed that has a width greater than 1/4 inch. All provisions allowing air to the wheel other than via the bore and the MWE groove are prohibited. No reducers of any kind to make a larger turbo pass inspection. No welding or remachining inducer bore to make a larger turbo pass inspection. Larger turbos and twins may be permitted if they are OEM for that truck.
 
Please dont bother patty just yet. I will let everyone know when and who you can get a hold of, so please be patiences. thanxs
 
anything other than street diesel?will they allow test and tune or maybe an exebition run or something along those lines?
 
Back
Top