McConnellsburg, PA Orlo Pull 10/16

mech2161

mech2161

I have a secret.
Joined
Jan 15, 2007
Messages
3,986
29th ANNUAL Show
GREASE STEAM & RUST ASSOCIATION, INC
FULTON COUNTY FAIRGROUNDS
888 Lincoln Way East, McConnellsburg, PA 17233

OCTOBER 16 7 P.M. START (GATES 5 P.M.)----

threshing1_b.jpg
threshing2_b.jpg
steamers.jpg


[MEDIA]http://www.gsandr.com/multimedia/show_flyer_2009.pdf[/MEDIA]
 
I had a great time there last year. Bring your winter coat.
 
ive always wanted to go to one of these shows to see all the other stuff, hopefully i can make it.
 
I'm glad they had the steam tractors last year. They were good for heat to keep warm at night.
 
Cold dont bother a fat kid like me, hell I sit in the woods for hours on end in the cold waiting for deer.
 
DIESEL: STREET CLASS --- 2.65 LIMIT INLET SIZE----NO REDUCERS.
TRACTION BARS ALLOWED.

I'm told this class is street only, factory intakes and exhaust?

HOT STREET-------2.85 LIMIT INLET SIZE-----IF TURBO COMES WITH GREATER THAN 2.85 CAN USE REDUCER TO
RUN HOT STREET.


MODIFIED DIESEL

1. Blocked suspension permitted.
2. Nitrous, alcohol, water, propane permitted.
3. Pulling type hitches permitted.
4. Bigger turbo(s), injectors, pumps, chips, dual turbos permitted.
5. Hitch height will be maximum of 26”
6. Weight bracket will be no more than 60” from center of front rear.
7. Bar and off road tires permitted only when extreme class run.
8. Hitch must be at least 27% of wheel base.
9. Any exhaust is permitted, vertical or horizontal, any pipe diameter allowed. Exhaust cannot exit toward spectators.
10. Tran- blankets strongly recommended.
11. Engine Kill safety devices recommended, Air shut off on fuel.


Pay Outs: They said don't expect much, the fair board is paying.

I can't remember what it was last year. It may have been trophies.

It's a good time and the last hook of the year.
 
mech2161 said:
DIESEL: STREET CLASS --- 2.65 LIMIT INLET SIZE----NO REDUCERS.
TRACTION BARS ALLOWED.

I'm told this class is street only, factory intakes and exhaust?

HOT STREET-------2.85 LIMIT INLET SIZE-----IF TURBO COMES WITH GREATER THAN 2.85 CAN USE REDUCER TO
RUN HOT STREET.


MODIFIED DIESEL

1. Blocked suspension permitted.
2. Nitrous, alcohol, water, propane permitted.
3. Pulling type hitches permitted.
4. Bigger turbo(s), injectors, pumps, chips, dual turbos permitted.
5. Hitch height will be maximum of 26”
6. Weight bracket will be no more than 60” from center of front rear.
7. Bar and off road tires permitted only when extreme class run.
8. Hitch must be at least 27% of wheel base.
9. Any exhaust is permitted, vertical or horizontal, any pipe diameter allowed. Exhaust cannot exit toward spectators.
10. Tran- blankets strongly recommended.
11. Engine Kill safety devices recommended, Air shut off on fuel.


Pay Outs: They said don't expect much, the fair board is paying.

I can't remember what it was last year. It may have been trophies.

It's a good time and the last hook of the year.
Click to expand...

Again the street/2.6 class and ruling baffle me?:bang
 
Dan is suppose to come to Mcconnellsburg Kevin. He wants to know who all will be there. Bringing this thread back for show of hands.
 
I should be ready. New tires are mounted and setting in the shop.

Tell him they will tech his truck.
 
i will be there just cause it is a good time, but dont expect much is right got 3rd in hot street at the fair there earlier this year and got $10.
 
mech2161 said:
I should be ready. New tires are mounted and setting in the shop.

Tell him they will tech his truck.
Click to expand...

I'm not telling him, just stand close when they raise the hood.:hehe: Do they run a open "anything goes" class? Only reason I told him about this pull is because he wants to pull against TJ. I set it up, but now TJ can't make it, Dan still might show though.
 
Last edited:
You must log in or register to reply here.
Top