phatshaft 62 400$

[kawi600]

just installed twins so this guy has got to go.
Got what I think was a 62/65/12 phat shaft turbo. found this was a great turbo for mild street and tow in the 400hp range on a 2nd gen. spooled even better with aftermarket manifold.
It has the usual small amount of side to side play and zero in and out play on the shaft.
the actuator has a dent in the top from the shock tower but I tested it with compressed air and it moves a full stroke and does not leak air.
also have an OEM oil pan and exhaust manifold.. and the 4" stainless downpipe I had with it if theres any interest in that.
Will try to get some pics if theres any interest
located in Boston, MA

 

[nike]

Still have this available? manifold, downpipe as well etc?

 

[kawi600]

yup, will get some pics of it shortly
Im not much of an expert on these so will try to get some measurements too

Looks like theres .032 play on the shaft measured side to side on the compressor side. no contact on the housings. I dont like the oily compressor side. someone told me this was the filter I was using so I brushed it off.. but Ill sell the turbo and the downpipe for that price if you want to run it.
I was going to get an OEM rebuild kit from borg and see if new oil seals helped but decided to just install the twins I had.
Its been in there awhile, so for that amount of oil on there I guess it did pretty good.
The actuator is ugly but still works fine.

 

[nike]

I don’t get on here enough. I still want the turbo and manifold if you have it. Sending pm with my cell number.