Ended up cancelling the order for the exhaust housing. They found me a used one at Stainless for 325, 50 off their new price and twice what the one I ordered was. So need to decide what to do on that side.
I made the decision to go ahead and spend the bucks on expanding my data logger sensors and ordered 2 new nodes. I ordered the 3 egt probes and the 2 three wire air temp sensors from them. Ordered 3 pressure transducers off ebay to use for the time being till I can swing the better ones if I need too.
So Node 1 will be setup like this:
port 1: EGT - exhaust temp
port 2: EGT - post turbo temp
port 3: Incoming air temp
port 4: post intercooler air temp
Node 2 will be setup like this:
port 1: EGT transmission temp sensor
port 2: Transmission pressure
port 3: post intercooler boost pressure
port 4: exhaust manifold pressure
After I get these in, should have some good data to make some going forward decisions with on turbo/intercooler, etc...
Got the pass front fender looking better last night, doesn't look like it has a lazy eye now from the front. If I make any more, need to work the mold a little bit and fix that angle on the back flange.
Also put a new 1k cca battery in the truck last night and colored in with paint pens my emergency shutoff switch to identify run vs off.