Set up help/sugestions?

fueled harder than the edge i ran. did not pop after i upgraded valve springs. tst comp is the model.
 
Going to drill my tubes out aginest your all's advice anyways tomarrow. If it does hurt me bad on power i can throw my stockers back in it and make power... .093 club here i come!
 
The line is ~ 0.070" ID and the feed passage in the injector body is ~ 0.065", what benefit would be created by enlarging the size between these two?
 
Honestly i did not know these dementions.... All i did was take the edge filter out of them. Was that ok? Becaues i still have a set of stock tubes i can run.
 
You must log in or register to reply here.
Top