RCCUMMINS89
New member
- Joined
- Apr 4, 2013
- Messages
- 191
Just went back and looked through my emails. The 6x13 we had tested flowed 4.35.
6x16 Scheid nozzle we had tested flowed 4.65.
6x16 Scheid nozzle we had tested flowed 4.65.
24 valve sac and 12 valve vco flow different per size.
I agree with the previous recommendation, I was simply trying to convey that it would be easier to grasp for those less familiar with flow values if the honed injector was referenced to as it's equivalent orifice size. There are a lot of options, but to be honest it never seems to amount to a whole lot on the user's end in my opinion, as long as the orifices are of good quality the cone angle is most likely the largest factor.
I agree with the previous recommendation, I was simply trying to convey that it would be easier to grasp for those less familiar with flow values if the honed injector was referenced to as it's equivalent orifice size. There are a lot of options, but to be honest it never seems to amount to a whole lot on the user's end in my opinion, as long as the orifices are of good quality the cone angle is most likely the largest factor.
Hiney!