Recent content by BenM

24 "Top Hat" style exhaust seals. In the packaging. Cummins P/N 3955394 $40 shipped OBO 12/12 Intake & Exhaust Cummins set of the conventional style seals $30 shipped OBO

Rods out of my '02 engine. They've been checked and straight and center to center within spec. Ready to be shot penned and polished. $125 shipped.

Used cam retainer plate. It was in for about 5k miles until I went to a SMT adjustable cam gear and used the one they provided. $35 shipped OBO

Don't know if these pistons could be of use for anyone for a 4BT or not. They were .020" Cummins 24v pistons that had .040" valve reliefs cut and coated by PolyDyn, Tops & skirts This engine wanted to be a 4Cyl so bad it gave 5 & 6 the boot. Lol The others are fine and the coating still looks...

6 Cummins Cam Bearings P/N 3940059 O.D. 2.335" .100" thick Coated by PolyDyn $100 shipped OBO

Is this the type of housing you were thinking about?? I don't remember if they had one for the smaller (less than 72mm) S400 units or not. I do remember this was a larger A/R .66 cover.

Sorry I missed your post wanting better pics. Here's 2 I found.

Have that long outlet cut down to something like this to give you more room.

Can't go wrong with the Maxspool Pushrods and Springs.

Not as good as it used to look so.. While it's out for a rebuild I'll go and clean it up a bit. If it can't go fast it'll look good going slow.

Looks great. I'd have a new coater if you were closer. Lol Since you have more experience in this than I. (I just pay the guy) A question for ya. I had my block powdercoated a few years ago 4-5. CAT gray was the color. It has some spots that have taken some bumps and scraps over the years of...

Forgot I still had the original fittings. If that makes a difference to anyone wanting. They're a few dollars that won't need spent.

Bypass Valve w/mounting bracket and rear plate from EatSoot.com Bypass was never used just sitting around. The plate was bolted to the block to mock up some braided stainless lines but I used a different setup since then. I have a new o-ring that'll come with it. $175 shipped for both. PayPal...

I'm needing to pull the 3 side plugs and rear plate that I purchased from you a while back for my '02 24v and would like to buy new O-rings for when I replace them. Can you quote me a price for them or if they are a standard item that I can buy locally I could do that. Thanks Ben.

https://www.youtube.com/watch?v=zsetV5Z-Mqc Maybe this will be a ongoing TV coverage for events like TS and SDX.