Recent content by Ether Man

looking for a 16 non waste gated housing for my father in laws 93 cummins. if anybody has one let me know what you want for it. thanks.

Well that H-11 material is bad stuff, drilled for a couple of hours with not much success so I had dad weld to it and then just backed it out. Wish I would have tried it sooner.

Ok so I had the studs Rockwell c scale tested this morning, they are suppose to be between 49-51 and these were 46 not sure of what that means. Anyway here is a pic of the end of the stud, the file mark on one edge is from the older gentlemen checking with a file.

Sorry about quality took with my phone.

anybody have bad luck with haisley h-11 12mm headstuds breaking? i just found my second headstud laying underneath the truck!!:nail:m Both that have broke have been on the exhaust manifold side, first was at the number 2 cylinder and today walked by and seen one laying under the truck and it is...

I need a stock 2nd generation valve body if anyone has one willing to sell.

alright i need help on any of these matters that you think you may be able to help me with. i have a 97 truck with a 97 wiring harness and a 96 motor and 98 tranny, oh yeah the ecm is a 96. all of the harness plugged in except for the tach, i had already installed the tach and had the motor in...

alright guys, on my half ton conversion i have a 96 motor and pcm in a 97 truck. i have had some people tell me that i will have to get a 97 pcm to work with my truck, i have talked to several people and nobody could give me a definite answer. just wondering if anybody had done this and switched...

Ok guys I have done quite a bit of reading on this subject but could not find anything specific for 1/2 ton conversions. I have a BD auxiliary cooler I was gonna run by it self with no heat exchanger or OEM cooler. This not a tow truck or race truck will be lucky to be 400 horsepower. Will this...

ok i am getting close to having this conversion done and i need to order an exhaust. i already have a 4" down pipe, but just wondering what everyone is doing for their exhaust. i want to just exit behind the rear wheel, not sure what kit everyone was ordering or if you have to piece it together...

ok need a run down on these two oil treatments, getting ready to break in the new cam i just put in and the only two oil supplements in my area that i can find for adding to my oil is rislone and lucas. rislone says 1 quart for every 5 qts. and lucas is just one bottle. anybody endorse one or...

ok guys my 1/2 ton conversion has started and i have already run into some bugs. first was i have a 97 truck and 96 motor and computer and wiring harness. i started installing the harness and one of the big 3 plugs on firewall driver side would not plug in so i am guessing i need a wiring...

wanting a turbo mouthpiece from an lbz for an lly. just thought i would see if anyone had one before i bought a new one.

Hey guys, Jim called me last night and left his number and i have misplaced it, if anybody has it pm me or if anybody can get ahold of him tell him to give me a call. Thanks.

hey guys i found a new in the box slave cylinder that i bought from Enterprise Engine back a few years ago. i bought it for a 02 model and never got around to installing it. it is suppose to be better than the stock one, but i have no idea what it cost so just shoot me a pm with an offer or give...