Well as the title says im looking at putting a p pump on my 24valve with a 03-04 common rail head. I haven't been able to find and threads that say weather you can or can not do it. So guys what do you say?
I'm looking for a GOOD cylinder head for my vp truck. No "it came off of a running motor" heads. Needs to have already been magnifluxed by a good shop! Does not need to be machined or bolt on ready just a good head.
Thank you
Anyone have any experience with a rebuilt motor from blackwaterengines.com? I'm thinking of getting one to replace my cracked motor. Just wondering any good or bad experiences with them.
Thanks
Neilden
Well I get my pump back from industrial and then I'm blowing threw my converter on my just refreshed sun coast trans. A buddie of mine and I take it for a drive so I can get his opinion on what is happening. And I look over and see my Check guages light come on after a couple of hits. I look...
My 99 24 valve with hot rod pump is giving me a headache. I installed a set of bd twins this week and after a short test drive went to lunch. After lunch the truck started up like normal with no problems. Went to leave and the truck died in the middle of the road. Fired right back up and...
I have a complete set of 3rd gen brakes both front and rear. I have sport rotors and yellow stuff pads for sale. None have been used or even mounted they are brand new!! I also have a full set of spare calipers with mounting hardware. I'm asking $900 + s&h if they need to be shipped.
Thank you...
June 25th clay drags at bithlo motorsports!! We have a diesel only class for all of you to run in. Only $20 to run 100% pay back racing starts at 7pm!!! Bring your trucks out and have some fun! And no you don't run in the bud pits unless you want to.
Well my driver side positive terminal is done. And my question for everyone is if anyone has found a suitable replacement cable end or should I just get an entire new cable?
Thank you,
Neilden