Recent content by okie18

So I thought I had just bent pushrods at D4D, turns out it's something else to. Replaced the push rods (10/12 were bent) and I still have bongo drums playing in the exhaust and sometimes the intake. Only out the exhaust when it's up to operating temps though. I'm leaning towards a loose valve...

So, had a common rail come in here while back that had 3 or 4 of the intake rockers not oiling the rocker bridges. I noticed all of the exhaust rockers were oiling with no problems. I pulled the non oiling rockers and flushed out the passages, the trunions and rockers had the typical galling...

Real living proof of a regular cab. Was a slt or a tradesman, cant remember.

What are yall using to roll your piping? I've seen the vise grip/exhaust clamp tool, I'd rather have a actual roller to do the job. Found this and it doesn't seem bad. http://www.grahamtool.com/wide-range-tube-beading-tool-1-1-4-to-6-free-shipping.aspx

Leaving burleson on the 8th and probably leaving from Lavon's on the 10th or 11th. The route isn't quite planned yet, one of the 3 choices that'll pull up on google probably. We'll be pulling a 35' gooseneck car hauler with my truck on it. So the rest of the space is up for rent.

So, not to mess up your build thread. What's the down low on the output modules? Can they be added to current EV2 gauges, etc... I'm really liking this for my trans cooler fans.

Anyone have a pdf or link? Figure it's not to hard to figure out but it'd be nice to read over before I swap my input.

Are there any other pressure ports besides the ones on the filter block?

Anyone have one laying around with 6" or so of wire left on it?

Changing the truck to an auto. So I'm selling all the 6 speed parts. Will include: -adapter plate -transmission Around 80K miles, I'll get the exact milage when I get back to the house. -crossmember with mount -clutch pedal -stock or southbend hydraulics -shifter and console -driveshafts...

Who has them besides Haldex/Sheid's? I've seen Hypermax's but I'm not sure what pressure theirs runs at. If I could find a pump like hypermax's I plan on running one of cooling mist controller's with it. I've also heard Bean's might have one but I've never heard anyone else mention besides...

Needing two of these with the plate and the v band. Thanks

I placed a wanted ad over on cummins forum around late november and he pmed me saying he had what I wanted. Which was two 2nd gen intake elbow bolts. I bought them on November 23rd and he supposedly mailed them out sometime around then. A couple weeks later I pmed him telling him I hadnt got...