I have 200% exergys in another customers truck with pulse cut back pretty damn far and makes around the same power as above setup...
Pushing our own agenda I guess. We're out of fuel no clue about 2.6.
Just curious how much you made before the limit is hit
In the spirit of vague information that is this thread is somewhere between 1000hp and 2000hp good enough....LOL
Its definetly a sweet set-up to see in person. Nice guy to talk to as well.
I could be wrong, but I think the reason top feed are used typically is the larger feed passage and a larger SAC nozzle, so you can get to a larger hole size more reliably without the tip coming apart in extreme power applicatinos. Like 0.020 -0.030
The feed passage in a lateral fed holder and top fed holder are the same size, and the nozzles can be interchanged between any holder that accepts a P-style nozzle with the proper guide size, so you could be wrong yes.
Typically in mechanical nozzles the orifice limit on a P-style nozzle is ~ 0.025", after that an AMBAC nozzle is used with a Stanadyne holder.
Just curious how much you made before the limit is hit
Rpm vs hp?? And you think it's fuel?? I'd say your out of air....?
That's bound to be an insane amount of RPM then if the LARGEST injectors out there can't get your prescribed shot in on time. Shoo wee!! How fast are you trying to spin that bastage?!?! How many degress past TDC are you wanting the shot to stop?
Lemme guess, in the interest of maintaining vagueness... Somewhere north of 3500rpm and stop injecting by 10-100* ATDC.
Am I remembering correctly, Joesixpack is the original zuess stand alone guy?