7x.11 issue

mcnamara0851 said:
I sold these injectors to Chris with 2-3k miles on them, I was having the same issue when I first installed them, but I thought it was due to my .093 crossover tubes. I ran a hundred miles or so and some seafoam through the tank and they progressively cleaned themselves up to where they didn't lope at all. If I knew this would be an issue I would have sent them in. I'll send you some cash for your troubles Chris. I hope Jamie clears this up for you, if not I'll pay Weston to do it.
Click to expand...

Thanks a lot for the help. Not your fault!
 
ChrisNickerson said:
Alright I just installed new injectors in my truck about 4 days ago, its a 1999 24v. They are CPP 7x.11 with .30 pintail lift. I have whats in my sig for extras, nothing special. Stock VP lines and Stock connector tubes. It idles at 780-800RPM which is fine but when i go to put it into gear it either A. drops RPM to about 500 RPM or sometimes lower then struggles to keep it self alive, or B. it stalls completely. Is this normal for this size injector? Is there anything i can do to make it not stall, like 0.93's or something? Any help would be greatly appreciated. The truck is still drivable just embarrassing when it stalls in front of people haha. Thanks in advance for any help

Thanks,
Chris
Click to expand...

Your injectors tested out perfect. The sealing washer was leaking bad. They will ship out Monday.

067_14115031_logo.jpg
 
I've seen a truck with cpp's do the same thing as the OP.
 
Last edited:
Can I join? I don't know what causes mine, but soon to rule out injectors.

[ame="http://www.youtube.com/watch?v=DD9ZoxzBSUc"]http://www.youtube.com/watch?v=DD9ZoxzBSUc[/ame]
 
Just wanted to let everyone no i got my injectors back from jamie and they still do the same exact thing? no difference.
 
You must log in or register to reply here.
Back
Top