inline only
wanna be
- Joined
- Aug 5, 2008
- Messages
- 324
The 06 Dodge Fine finish Concrete truck has been parted out. I would like to sell engine first before other parts sell otherwise I may as well keep it all and put in another truck
Complete engine-- Harness starter and all.
Balanced rotating assembly
Scheid cam Strip/track
ported and o'ringed head
valve springs
head studs
Ross pistons
Flux 4.3 injectors or II 300hp tips
II dual fuelers dmax top pump, was told both were stg3 but lower looks stock
2.8 S400 with 2.6 race cover 90 ex 74 83 wheel i believe
PDI T4 tapped for 8 pyros
Factory fuel filter housing delete
Chrome intake horn and dual pump radiator pipe
rear freeze plug blocked off
Electric water pump
manual ECM
Haisley dual disk comp puller
air shut off
even has A/C compressor
Drop it in and roll
engine and clutch have 25 hooks at the very most
10k for complete package or i can take some bolt ons off to make it cheaper but only if engine is selling at that time
If engine sells i got
NV4500 with big input with shifter
271 t case still bolted to trans
upgraded hydros
Complete AAM front axle with 488 gears and ARB air locker
front axle has control arms, springs, shocks, tie rods, steering box, rotors calipers
Rear AAM stock LSD carrier with 488 gears and bearings
Flex-a-lite dual fans with complete alluminum shroud
Alot of other small stuff
Complete Air to water set-up, but Smokin-u has first chance
All parts are located in Hopkins Mo
Complete engine-- Harness starter and all.
Balanced rotating assembly
Scheid cam Strip/track
ported and o'ringed head
valve springs
head studs
Ross pistons
Flux 4.3 injectors or II 300hp tips
II dual fuelers dmax top pump, was told both were stg3 but lower looks stock
2.8 S400 with 2.6 race cover 90 ex 74 83 wheel i believe
PDI T4 tapped for 8 pyros
Factory fuel filter housing delete
Chrome intake horn and dual pump radiator pipe
rear freeze plug blocked off
Electric water pump
manual ECM
Haisley dual disk comp puller
air shut off
even has A/C compressor
Drop it in and roll
engine and clutch have 25 hooks at the very most
10k for complete package or i can take some bolt ons off to make it cheaper but only if engine is selling at that time
If engine sells i got
NV4500 with big input with shifter
271 t case still bolted to trans
upgraded hydros
Complete AAM front axle with 488 gears and ARB air locker
front axle has control arms, springs, shocks, tie rods, steering box, rotors calipers
Rear AAM stock LSD carrier with 488 gears and bearings
Flex-a-lite dual fans with complete alluminum shroud
Alot of other small stuff
Complete Air to water set-up, but Smokin-u has first chance
All parts are located in Hopkins Mo