CR pulling engine and parts

3rd gen clutch pedal
$30


Is this the whole pedal assembly? Do you have the boots for the shifter?
 
Yes I do. and the shifter, yes pedal is complete pivot pin and master pin, if I recall correctly that is all that is needed the mount should be in the truck.
 
i'll take that rp gauge, how much and can you either pm me or give me a number to call. thanks
 
HEY!!! i'll take that rp gauge, please pm me as i dont have the post count to pm you. CASH in HAND waiting. seriously
 
Whats left...

Complete AAM front axle with 488 gears and ARB air locker, with compressor, harness and switches.
front axle has control arms, springs, shocks, tie rods, steering box, rotors calipers
Rear AAM stock LSD carrier with 488 gears and bearings,
Would like to keep axle stuff together
$1800
rear axle housing available if needed.

autometer phantom white face gauges, 3 0-2000 pyros, 1 0-1600 pyro all other gauges sold.

Complete Air to water set-up all brackets and pipes to hook to stock intercooler pipes, hoses, cooler for tank with bilge pump, alluminum plate that bolts to floor where rear quad cab seat goes.
$900
Haisley Comp puller dual disk, 25 or so hooks, has been hot but no chunks missing never had shims removed.
$1800
NX express kit with big bottle, stainless braided line from tank and also to gauge, don't know solenoid or jet size
$250
Snow performance kit with pump, controller, and small tank not sure if its all there
$100
New take off 2nd gen white tailgate, perfect condition
$200
Alot of this stuff will be difficult to ship, PM me with questions
Thanks, Scott

All parts are located in Hopkins Mo
 
You must log in or register to reply here.
Top