Lazarsmith's G56 brace

Strange... I just checked and there's less than .005" difference between the OEM E-heads and replacement allen socket heads.

There's indentations in the case casting ears to drill the holes - takes a couple minutes to do all of three of them.
 
I wasn't sure so i didn't drill em. There are also ears on top of the trans that I would've had to drop the trans also to drill. No biggie. As far as the bolt length goes, the cap screws that were sent are about 1/4 inch shorter. IIRC. I could pull one to measure more accurately but there are more than enough threads for the factory E's to work.
 
Hmm - since we've only ever had 1 part number for those, I suppose it's possible the hardware manufacturer could've sent the next size down by mistake... email me your address and I'll send a correct-length set.
 
You must log in or register to reply here.
Top