Recent content by RudolphD1

Hello, I have been lookin at this 83 Van. It has a naturally aspirated diesel with a 700R4 tranny behind it. Guy says he only used it pull boat twice to lake and back each year. Boat is gone and so its for sale. Seems to a good running van except I'm concerned about parts availability and...

I am looking for a HD Tranny Kit for my 3 Speed 727 Automatic with NO overdrive. Truck is powered by 12V Cummins so it needs to be heavy duty. Anyone done one before and got experience/advise? Advise on best place to buy the kit. Thanks.

Trying to find a 3" Body Lift kit for my 92 Chevy 3500HD which has Cummins and NV4500. All the kits I find state "Not for Diesel Engines". Where can a locate a kit for my Diesel Truck, and what makes the diesel different, please? Thanks.

New M/C installed. No leaks, hardware good. Cannot get a good pedal. Truck will stop but the excessive pedal travel is scary. Was told dealer is the only one who can bleed these because dealer can cycle the ABS and remove excess air in module. Another person told me the modulator valve might...

If someone has an Oil Pan For 94 12V 6B Series Cummins please let me know. Thanks. Rudolph

If someone had done this, please tell me how you went about it. Modifications done, motor mounts used, lessons learned. Would like to have pics of Cummins engine sitting in Chevy. So far I have removed equal amounts from sides of main cross-member but engine sits too high to attach NV4500...

I have a 92 Chevy 3500 with 5.9 Cummins engine. I replaced the GM clutch master cylinder with a Dodge Clutch Master cylinder. (Dodge provided more power to disengage clutch.) I removed the two bolts on firewall to be able to twist and turn the Dodge replacement. I have tried everything to...

Got a 89 12V Cummins that just stops for no reason. Has new transfer pump, plenty of fuel, and fuel is getting to injectors (cracked lines to verify). I am in Wyoming, but the Jelling is not a problem(yet). What should pressure be coming out of transfer pump so I can verify I have not got a...

I have a 94 Cummins in a 92 Chevy 3500. It goes without saying the space is very limited. It appears the exhaust manifold and the turbo could be inverted allowing me to reroute the exhaust pipe so that so much heat is not around the firewall and wiring. Has anyone inverted one? Were...

I need information on the types of motor mounts and modifications necessary to fit the Cummins into a 92 Chevy. I bought this used Chevy with the Cummins, engine is not level, the oil pan is nearly against the cross member, and it is impossible to install the NV4500 transmission. HELP...

Looking for 94 Dodge Cummins Flywheel, 14 5/16 inch diameter. Located in Wyoming. 304 4838394

Need 22 tooth input shaft to replace my GM 4500 input shaft. Also need an adaptor plate for Cummins to Dodge bellhousing. Thanks RudolphD1

Have installed 5.9 in 92 Chevy 3500HD. I have newer NV4500 Chevy Transmission with 22 teeth. Was told I need to intall: Engine adpator plate for Dodge Bell Housing A Dodge Bellhousing A Dodge Input Shaft A Dodge HD Clutch kit A Dodge Slave Cylinder Any Suggestions please? Will existing GM...