Twins Progress (pics)

Thanks. Couple more from tonight...

IMG_9834.jpg


IMG_9835.jpg
 
jessmeistertc, have any pictures of your truck, I would like to see the stance with it lowered? how did you go about lowering it?
 
the s300 exhaust outlet flange came from Forced Inductions and the s400 inlet flange came from Source Automotive.
 
rockjeep73 said:
jessmeistertc, have any pictures of your truck, I would like to see the stance with it lowered? how did you go about lowering it?
Click to expand...
before and after. its getting different wheels soon. but anyway, ordered 3" lowering springs from Coil Springs Specialties and took out the 4.75" blocks from the rear. there are a couple of leafs MIA too. 35's on old setup and about a 32.5 tire now
dodge2.jpg
dodge.jpg
 
Wow, nice truck, I like the lower look. Sorry on the thread jack. At least its easier to work on, than a lifted ride.

Rockjeep, you do nice work. Have you put any miles on the new set-up?
 
Nope, im still trying to get it all built and put together. I have parts at the ceramic coater and the powder coater right now. Im hoping to have it all together and running sometime towards the end of next week. I will update as I go.
 
Looks good corry! How you been? Ill get you some pics of my truck lowerd
 
millerlhc said:
cold pipe? Size witch is better 3 1/2 or 4 inch?
Click to expand...

From what I'm told the smaller pipe keeps velocity up and helps out for street/towing unless you have ridiculous amounts of fuel. If I'm out of line I'm sure someone will correct me.
 
CTDYoungGun said:
From what I'm told the smaller pipe keeps velocity up and helps out for street/towing unless you have ridiculous amounts of fuel. If I'm out of line I'm sure someone will correct me.
Click to expand...

all im going to say is 3" tubing flows a HUGE amount of air. the cold pipe also flows alot less air than the charge piping....
 
Has anyone played around with running a 3" cold pipe into a smooth bore comp cover? I'm just thinking consistency in airflow here...not sure if the MAP groove on the secondary plays a big part or not?
 
I built my cold pipe and hot pipe out of 3 1/2". The outlet of the s400 is about 3 1/2. I mainly did it for less volume.
 
Looks good buddy. You do nice work. I just finished my twins up this weekend as well but my welds are not dressed/cleaned/painted:blahblah1:

I built a set of GT3788R over a S475, with a few adjustments.
 
You must log in or register to reply here.
Back
Top