Recent content by torqueman

Anybody running them with aftermarket wheel flares. Looking to c where the wheel sits on the flares. Thx

I have a 2012 and navigation just quit working one day. Now I just get a Garmin message. Is it possible that navigation expires after 5 years. Or what else could it be. Thx

I've installed a set of stainless 58/475 with billet wheel on the 475 on my 98.5. What I'm looking to hear from other people is what kind of turbo pitch u r hearing from twins. This set sounds almost the same as my stock hx35 without the ring but louder. I was expecting a more deeper whistle...

For sale with low mileage. Upgraded to twins. Also have downpipe if needed.Has polished housing. $900.obo

What's the best way to disable the rear abs on a 98.5.

Slt trim,sport package all black,remote start & roll up tonneau cover with spray in bed liner. $20,900. OBO

SLT trim with tow package and mirrors. It's a black truck with sport package. One owner with 204,000 kms. Asking 20,900. OBO

I've been running iquad for awhile now and would like to go back to a drag comp. But it would b nice to have the gauges & data logging from the iquad. Do u guys think it's possible to run both together. Thx.

Just wandering if anyone's had this problem. It clears up in a minute or so. I run the iquad and Mach 5's. It's got a sopump to.

Well it all started when I changed my rear pads. Since I changed them pedals been weird. Lower than usual but if u pump them they come right up. Bled them and changed calipers to but no change. What do u guys think master cylinder or what. Maybe crap plugged somewhere too. Thanx

Does anyone no if you were to leave a comp on while truck sat for a few days what might happen to it if anything. I had it temporarily hardwired and I might of forgot to shut off.

Well truck won't fire up and six DTC's. They are (po253 IP fuel valve open circuit ,(p1689 no comm. Between ECM & IP,(p1693 dtc in PCM or ECM ),(po602 fueling calibration error),(po230 transfer pump circuit which is because I don't have one. )(po236 map sensor read to high to long). What do u...

Have any of u guy's running drag comp ever had issues with motor breaking up and sputtering on wot runs.I'm thinking it has to be electrical just assuming its the drag.I had the truck into a 13.50 quarter and since then I've upgraded to a spearco intercooler & a helix 2 cam & springs.This...

I know I'm a little late with this deal but it still bugs me what happened.I bought a set of So called Mach 5's from a guy on this site that was good to deal with.I already had mach 3's in my truck so I put the new Mach 5's in expecting to get a nice jump in power and it just wasn't there.I had...

I have 2nd gen 24v and has original 180 deg thermostat.Anybody running anything higher than that.Has it helped with more heat in the cab...Thanx