Recent content by Spooler

I am having a 3rd to 4th slip with moderate throttle input. What controls this shift? Do I need to adjust the back band? Once it shifts it is fine and will hold the power with no issues. I only have an issue every now and then. It's not constant.

This charger has 60,000 miles on it. Had no issues when I pulled it off. I do see some slight rubbing on the compressor housing. End play checks out as none. 3rd Gen setup. Wanting $1000 shipped to your door in the US.

Figured you might enjoy this. I just installed a new turbo and the old one would spool up about the same. After I installed your cam this is what I got. The only additional thing I have done is install a Steedspeed exhaust manifold and it did help some also, but not as much as the cam. It's a...

What is the difference between a bar and plate design compared to a tube and fin design? Trying to figure out the difference between an Hellman CAC and HTT CAC.

Is it true that Steed Speed is going to stop production on the 3rd Gen manifold?

It was looking good to upgrade to a set of twin garrets. GT3788r over a GTX4508r. The cost is tough. Not sure if I should stick with this setup or go for my current single HTT 62/71/13ss over a S478. Funds are not looking good for the Garrett setup. Still need to do springs, studs, upgrade...

I have been thinking about going to compounds. I do tow heavy with the truck. What are the benefits and pitfalls of going S475, S476, or S478. Which one would work better for me? I have been thinking about the S478 with a 1.1 a/r.

Got the new manifold on the truck today. I gained in the 1400 to 1700 rpm range. Lots better spool up. I got just what I was after just like the dyno graphs showed I would get. I'll know how it does under a heavy load in about a month and 1/2 when I go get hay again. I did notice something else...

Any one ran a 63/71/13ss with the billet 63 wheel? I need a little more air up top. Spoolup is great the with the cam and 62/71/13ss. I have been thinking of upgrading my current turbo or replacing it with a billet 63/68/14.

Pulled this turbo off my 04.5 at 38,000 miles. $500.00 plus the ride.

I have had an issue for about the past 6 months with flucuating fuel pressure. I pulled the regulator spring (17 psi) out to find the ball stuck inside the spring. I corrected the issue and it lasted for about 2 months. The other day my fuel pressure dropped down to 6 psi. Changed all the...

When is the next Garmon dyno day event? Thinking about making the trip.

I am wondering how a S478/92/1.10 A/R will work in a twin setup for me with my 62/71/13ss. The truck is fun as heck to drive since I installed the Hamilton cam. I am also wondering what size injector I would need to upgrade too.

Just wondering if anyone on here uses one. I have a Greedy Spec V new in the box at the house I was thinking of installing.

I just upgraded from S06 to S06-POD. I downloaded the latest S06-POD software and I am unable to install it to my Smarty. I keep getting a " Unkown Software version of Smarty" when I try to install it. Bob or Marco, can you give me a hand here? I do have all of the latest drivers.