Search results

150hp standard spray angle they were 90 nozzles flowed 4 times from industrial. I believe they are the largest dragon flys, and were installed in a customer truck driven 100 yards pulled them out and returned them. he set his timing wrong and blamed the injectors. so they have been sitting...

have an 06 3500. what it does is at 18-2000 rpm it will cut out blow fuel smoke then pull out of it and run fine. when it does that it dumps the timing. not sure of what the base is but it will go from 4-8* to -3-6*. it starts cold or hot fine, does not do it all the time. it has...

I have a Banks twin ram with no grid heaters rv style. 525 shipped have a banks power elbow i believe they called it bolts to the back of the stock turbo and gives it a 4" outlet with associated down pipe 250 shipped have a never installed pdi manifold t3 type 425 shipped in north idaho...

I have had a sleuth of them come in with trashed flywheels and the upper d-side part of the bell housing broken......anyone else???

Is there a way to verify the health of the lifter/roller needle bearings with out pulling out the motor? The lpop ate something and shared it with the rest of the oil system. All Screens destroyed metal through out. I was Told that the needle bearings in the roller tips are a likely suspect...

I have an 05 140k died driving down the road no codes towed to shop and it will not build oil pressure. it had 5 something gallons of oil in it when I drained it to check the lpo regulator which didnt appear to have a problem or anything stuck in there with it. the truck has had injectors 2...

What are the silver bullet and the HTT equivalent good for in regards to boost before its not doing a person any good? Its seems every turbo has a breaking point I was J/C what it was on these..... Thanks

Title says it hopefully one still intact and usable

do you have to run an auto pcm to use this, or can you do with out?

I have a 98 12v with a 5 speed and I have a guy who want to swap me for his 47rh what all will I be needing to get from the guy to make this happen?

how big is the compressor/turbine wheel on the stock 3rd gen turbo?

I would like to find the following: 215 injectors 181 delivery valves 191 delivery valves flat top barrel and plunger assembly in decent shape or even a decent core pump. Some one has to be able to help me out on this stuff. The closer to Idaho the better on the pump if its the whole thing...

I have a customer that brought in two 7100's one is off an f700 or something it is a 190hp It was on his truck(converted ford) and didnt like starting when hot, so off it came the other came with a motor that was purchased I believe a 94 and looks like it has sat a good while. figure they are...

I would like to get a set of .093 or .084 for a 12 valve

How many pounds are you guys running or are you just running the 18psi?

why would a truck that is supposed to run on an 235 not run on it but will run with a 245 pump in it(about 95% correctly)? It will not even attempt to pump fuel with the 235 in it and gives 1689 no communications code. should I try a new ecm? 02 5spd 80k stock 18psi idling new cam sensor...

Does the 913 series 215 pump have that dumb light load advance cut into the helix of the plunger? If so is there a series of 215 that doesnt?

I have an 02 in the shop and it came to me with 4psi idling and no throttle response with 1698 and 0216. So new pump and a raptor 150 and it ran ok for for a bit then developed a hang up from 1500-1800 smoke real bad blubber and come out of it. Checked the tpps with the scan tool 4 times no...