Search results

84/113 x 88/96 .66 cover with .200 MWE 1.32 T6 ex. housing Billet wheel 360* thrust -6 inlet fitting 8 hooks $2000 plus shipping

Finally got the build trans installed and took it out for a drive. The lockup switch does not work. I verified all of the wiring, and have decided I have one of the PCM's that doesn't allow this to work. My question is, if the jumper wire in the PDC supplies the power to the solenoid and the...

Got everything back together and made a pass over at Leon, IA with the MPA. http://youtu.be/O2x1_eqJz2g

Ok I have a question about a 5.9 engine stand. I did look through the old threads, they are closed, so I am posting this. Does anyone feel that you should support the block on both sides? Is it too much weight to hang a complete engine from one side mount? Opinions?

Finally got it all together and made it to a pull. My brother pulled in the 7500# class, made it 286': I pulled the 8500#, 293' A big thanks to Weston for the fuel.

I appears that Dana does not make 5.13 gears for the 60? Or at least I could not find them. Has anyone ran Richmond gears? Are they good or should I get a different brand? If so which one? Thanks

I was wondering what the recommended piston to valve clearance was for a 12 valve? It will be in a pulling truck. I did a search and didn't really find anything. Thanks

Good used 31 spline input gear for NV271/273. Out of a 2001 or 2002. $75 plus shipping.

I am in the market for some 35 spline outers for a dana 60. What are good ones to get? Are the spicer's good enough? What about the lockouts? Mile Marker or Warn? Or ?? Here's the stock one:

Like title says, I am in need of a RG spacer for the dana 60/61. Apparently they are no longer available from Reider.

Still have some of this stuff left: 4340 5" x 4" bar stock. New condition, stored indoors. Approx. 12' lengths. 68#'s per foot. Could bring to TS. Looking to get $0.36/lb for full sticks. Consider trades for Dodge stuff.

I was wondering if there was a optimum amount of toe-in for pulling? Had the tie rod off and was wondering? Thanks

What is a good source for a new 12v head? Nothing too crazy, but will have it o-ringed. 60# springs would be a plus. What is the best way to go? Thanks

4"x5" E4340 bar stock, 68.06 pounds per foot. 17-5/8" is about 100 lbs. Comes in 12 foot nominal lengths, or cut if you want. Anybody interested in something like this?

I am looking at several water to air IC's. Who has had experience with these? I am looking to put it on the '89. I would prefer 3" inlet/outlet to match the piping, but some are 3.5 with the same core size. I figure 3" would allow the use of "hump" couplers rather than reducers, as it will be...

Well, I have been making progress on the '89. 60mm H1C with ported 12cm over HT3B. I have the WG hole opened up to 1.5" with some machining left to do. Here's how it sits. The hot pipe with be thermal wrapped. I have a wrap for the 3B hot side, is that worth using?

I am going to be switching to an electric lift pump. It will most likely be an A1000. What do you recomend for a filter before the pump? Aeromotive recomends thier $100 inline unit, are there any other options? Can you use say a 50 micron water seperator/ fuel filter before the pump? Or does...

Title pretty much says it all. Ventured over from another site. Just wanted to say hi.