Search results

I installed a new set of 5X014 Sacs last weekend. Fuel was seeping through the threads of the hold down nut for the #3 cylinder. I removed it and did a 2nd check on the exterior of the injector body and injector bore. Everything looked good so I re-installed only to have the same problem...

Hey everyone- I've searched without much luck about the 12valv controllers the turbo in mind is a 60mm he451ve Wondering if anyone is running the totally stand alone MAP only controller yet? Is tuning the same as the 24v trucks? I saw some instances where folks are ending up with some very flat...

Hey guys- Ate the splines out of the 3-4 synchro inner hub and am looking to do a full rebuild, maybe cryo some parts and update the main shaft. Has anyone successfully rebuilt this trans without investing as much in specialty tools as parts? The small hand tools are not a problem but the...

Looking for a compressor wheel and shaft/turbine wheel assembly for a GT4294. Also interested in in the parts require to move up to a 4204 if possible.. Thanks

Hey guys- Considering a flat paint scheme for my truck in the near future. The paint job will be on somewhat of a budget, hopefully a few steps above a bomb can job but nothing real special. A professional will shoot it but I'll do as much of the paint prep as possible, with some guidance as I'm...

Hey guys- Currently have a ETT 66/74/14 WG on the truck as a single with some 5x.012s. Its a pig (5 speed, stock gearing, larger tires) and is no fun unless I'm turning a bunch of RPM (that I don't really have) up on the highway. Been trying to get a cam in the truck but in the mean time have...

Hey guys- A friend has a set of injectors off a 97 that have been extrude honed to 46 lpm and the pop pressures raised slightly for sale. I've searched all over and have found very little info comparing lpm to hole # X hole size or a HP rating. I either see very low lpm numbers or stuff in the...

Hey guys- The new turbo came with a 2 piece charge pipe to use after the 90* silicone elbow off the slip fit compressor outlet. From what I can tell it is to ease installation since there is no longer a v-band outlet to line up and clamp. Now its kind of a back and forth game to get both ends in...

Hey guys- Trying to install my S366 and I'm having some issues tracking down the correct feed line fitting. The truck is a 97, the original fitting on the HX35 end of the oil line is a tube/flare end of some sort using a copper washer and the threads in turbo cartridge are STORM from what I can...

Hey guys, Looking to read up on the internal workings of the p7100. I've searched and came across a thread or two but was wondering if anyone had some links to help a guy understand the operation of the "stupid" pump. Any help would be appreciated, thanks. Ps- what is the technical name for the...

Hey guys- I did the basic AFC mods today (didn't get to drive it yet) but have some questions regarding what I found trying to set travel with shop air... I searched prior to posting w/o luck. I cut about 1/4" off the barrel (didn't touch the face of the afc foot), ground the washers flat and...

Hey guys- Trying to figure out what route to take with the truck. Its turning out to be a cost vs. resources thing as I'd like to build a set of twins (s300/400) but won't be able to have the truck off the road for awhile as its my DD/tool hauler. Buying a full twin set is out of the budget...