Search results

I'm looking for a good 1999 Dodge auto ECM. The part number on mine is 3942336

My truck has been sitting for about a week and I went to start it tonight. The truck started fine but immediately idled at around 1000 rpm. (higher rpm than normal idle) And it would do nothing when I pushed the throttle pedal. Dropping the truck into gear it stayed at this same rpm. I'm showing...

I went to start my truck and the lift pump did not kick on and cycle when I turned the key on, nor did it kick on when I bumped the starter. I got looking around with a test light and narrowed down my problem to where I was not getting power to the plug for the stock lift pump. I have my FASS...

I haven't been on here for a while but I met Phil this weekend at our Monster Jam show here in Nashville and thought I'd post some stuff on here that I've been dealing with on my Dodge lately... The top mounting hole on my alternator pulled the bolt through and I'm needing a new one. The...

I lost my original VP44 about a month ago after 208,000 miles. I installed a new Scheid VP44 from Haisley and got the truck going again. I ran the truck for a few days to get it going again and then installed a brand new FASS 95 system which I had sitting here for a few years. The FASS has been...

I was just leaving my place this afternoon and all of a sudden as soon as I pulled out onto the road the truck died. I coasted into a parking lot and tried to re-fire with no luck. The truck just cranked over and wouldn't fire. I have a Scan Gauge II on the truck and scanned for codes and got a...

I was on my way to church this morning and my speedometer started acting up going to like 127 mph for a few seconds at a time. That is all it was doing. I just went to leave church and head to the shop and more problems... As soon as I turned the key on the speedometer instantly pegged out...

So I've had water on my passenger side floorboard off and on all summer. And noticed more and more anytime I turned the temperature control towards heat a bit of a smell of antifreeze. And now I've been noticing more and more that anytime I have even just the heat on my windows are fogging up...

I'm going to need some new tires on my truck here before too long. I currently have a set of 315/75/R16 BFG All Terrain's on 16x10 Pro Comp wheels. The tires on the truck now measure out at about 34.5" I'm not exactly sure what lift/leveling kit is in my truck but the front spacer does measure...

I have been searching for a set of 33x15.50xR18 Mickey Thompson ATZ's and have found that they have been discontinued. I had one of our trucks on display up at the 4 Wheel Jamboree in Lima, OH a few weekends back and talked with the guys from Mickey Thompson as well as a few of the larger...

I ordered a set of the 1 piece clear headlight housings and going to try them. I've read both good and bad about them on different sites and decided I'd give them a try. I've been running the Silver Star bulbs in my stock housings for a while now and just wanting to get some more light. I think...

Well I'm finally breaking down and putting some new breaks on the truck. I've got Mopar replacement rear shoes and I'll just turn down the rear drums as there's plenty left but I know the front rotors will need replacing. They're warpped pretty bad mostly from the previous owner and I have...

Been watching my fuel pressure and every now and then it has been dropping a bit. Hasn't really gotten below 9 psi but when I have the Juice on level 3x5 and wide open it does pull it down. Think it might be time to replace the ol' stocker now that the truck turned 180,000 today. The mods I have...

Got my Edge Juice installed a while back and didn't tap the pump wire or install the boost elbow when I installed the juice. Wondering how much of a difference either of these make? Been happy with the juice so far just wondering how much of a difference either of these will make in addition to...

Looking for a product for cleaning aluminum wheels. When I get my tractor trailers washed at a truck wash like Blue Beacon I have them use their "Citrus Shine" product on my wheels and they come out great every time with little effort from them guys. All they do is brush the stuff on and wash it...

Well, I broke down Monday and ordered my Edge Juice with Attitude for my 99. Been looking to get one for a while and decided to order it so I could get the rebate they have going on. Any advice or tips on the install? And anything special I should know about it when I get it going? Thanks for...

Finally got around to checking out this site and joining. I had a chance to make it out to the pull in Springfield, TN a few weeks back and heard about the site there. A little bit about myself: I'm originally from Ohio (Cleveland area) and moved down here to Nashville a few years ago. I race...